Spring M
spring-manufacturers  

Home

Company

Technical

Contact Us

Testimonials

Spring Manufacturer Slides

Katy Spring Articles

Katy Spring Press Releases

Katy Spring Feedback

Katy Spring Employment

Katy Spring Site Map

 

Online Spring Catalog

   

Houston Spring Manufacturers Provide the Best in Spring Load Testing Equipment

Every company that uses commercial springs needs to consider obtaining spring load testing equipment. Quality Houston spring manufacturers can help you decide which product can help you foresee load testing problems, avoiding a spring load that is not inadequate. It is vital to have a full range of springs, so that you are not caught in the dilemma of using a compression spring that is really too large for the application. Depending on the equipment’s accuracy, you should not use a load that is below 10% to 20% of the scale’s capacity.

Consider the following when choosing load testing equipment:

Load height and cell calibration: In order to stay accurate, spring load testing equipment has to be calibrated regularly. The master weights need to be traceable to the NIST, and load cells should be calibrated and tested through the range of the tester to ensure that the load cell is linear. Also, the height readings need calibration, using gage blocks, throughout the scale’s range.

Load cell deflection: Since every load cell deflects the applied load, it is important to compensate for this load deflection when testing compression springs. Of course, electronic spring load testers do this automatically.

Load cell alignment: The top platen should be parallel to the load cell platen, which can be done by brining the platen down onto a gage block and moving it around to the outside of the cell. The block and the load cell should be parallel to each other, within a fraction of an inch. This type of precision can be accomplished using shims or adjusting screws.

Leaning effect on the load: Springs tend to lean a little bit, which is sometimes referred to as “squareness”; and this leaning can sometimes effect the load testing equipment. When there is significant variation between checking the spring standing on one end and checking it on the other, the customer an supplier need to agree on a single measurement method.

Hysteresis and friction: Because springs touch the fixturing, friction is always a concern. Also, because the coils wind up when compressed and the end coils twist and move on the platen, there is hysteresis, even when the user is testing a compression spring is not over a pin. Oil can reduce that friction, but the best solution is to test the load while it is approaching the load point, and then to test it again after going past that point. This method averages out the friction or hysteresis.

For all of your compression spring and spring load testing equipment, turn to the Houston spring manufacturers at Katy Spring. We have the expertise and equipment it takes to keep your company complete applications and product orders efficiently and safely. Call us today at 281-391-1888.

Bookmark and Share

Compression, Extension and Torsion Springs

   

   

 

Please send inquiries to: sales@katyspring.com
Ph. 281-391-1888



Spring Manufacturer

Spring Manufacturing Institute

Spring Manufacturer
Spring Manufacturer

Follow Katy Spring:

Home | Company Info | Technical Info | Catalog | Testimonials | Contact | Site Map | Stock Compression Springs | Stock Extension Springs
Compression Springs | Extension Springs | Torsion Springs | Flat Springs | Wire Forms | Slideshow | Spring Manufacturer |
Katy Spring Blog
| Precise Compression Spring Requirements | Spring Manufacturing Quality | What is a Compression Spring?
Large Compression Springs | Small Springs | Heavy Duty Springs

Website maintained by Masgraphics

© Copyright 2000-2016 KATY SPRING & MFG, Inc. All Rights Reserved. Katy Spring is your source for custom formed spring metal component spring manufacturer. We have Compression Springs, Extension Springs, Torsion Springs, flat Springs. Spring manufacturers