Compression Spring Grinding
Compression spring ends often are ground to increase operational life and to allow the spring to sit squarely on the load-bearing surface. Grinding of compression springs also increases the number of active coils and the wire diameter available in a given volume of space, which can result in higher loads or lower stresses. As a modern compression springs manufacturer, our facilities operate with a wide variety of equipment – from hand-operated grinding tools to automatic, high-speed vertical spindle disc grinders.
Compression Spring Shapes & Sizes
.007 to .625 inches in spring wire diameter
Up to 2.0 Inches
Compression Spring Round Wire
Compression Spring Square Wire
Compression Spring Rectangular Wire
Compression Spring Special Section Wire